TUNING YOUR TV TO LINC UHF 68

Note: Tuning can only occur whilst we are broadcasting (video signal).
Daily from 6pm until late.

With most modern TV’s and VCR’s you will need the remote

1. To start scanning or channel set press the menu button
2. Next go to tuner set-up and press ok
3. Next go to auto tuner set-up and press ok
4. Next go to b/g Aust for system country and press ok
5. Your TV or Video will start scanning for new Television signals and should keep the other channels as they were
6. When done you could just leave it or press ok

Older models with switch and dial tuner
Here are some tips on improving your reception.
Manual tuning for UHF settings:

1. To start select a channel you are not using; generally not 1 or 2 because these channels are used for tuning the VCR to the television
2. You may need to alter the band selector in the tuning control section
3. The UHF band is identified on the television tuner with the letter U (VL, VH, U) or C (A, B, C)
4. The set then needs to be fine-tuned to frequency UHF 68 by turning the dial until Linc TV appears on screen

This applies for the Lismore area only